This is a replacement motor unit made for a Premier 751 vibraphone. The on/off switch, and potentiometer are on fly leads so that they can be fit either side of the leg hinge, on the underside of the high end transom. The grey box contains the speed control PCB, capacitor, and various connectors, with an IEC socket fitted so that the power cable can be removed.
The motor carriage is made to fit 750 & 751 vibes, but will probably fit older models. Like everything I make, it has been designed to overcome problems that I have had to repair many times. This carriage is not only strong enough to actually hold the motor, but will actually stiffen the note rails and their joining piece.
Locating the pot and on/off switch to the end frame avoids the normal difficulties experienced when bowing the notes, and the leg hinge will offer protection to the components during transportation.
The grey box is the brains. The IEC socket was a moment of realisation during conversation with the customer. By using a standardised socket as opposed to permanently wired, prevents straining or damaging the cable which occurs when winding it around the instrument, and makes replacement simple. In fact finding a replacement cable on a gig is now simplicity; just borrow the cable one powering the kettle, or pc, or guitar amp, etc, etc. Additionally, there is now no need for anyone other than myself to open that grey box! Finally, there are two small holes on the side, the small one is the power led on the PCB, the larger one is access for the trimming pot which can be used to increase the maximum speed, so can be ignored.
To fit it, six holes need to be drilled, four for the motor carriage and one each for the pot and power switch. Then its just a matter of routing the cable.